6. USE
26
SYNTHESIS GAS
6. USE
During cooking or at the end of cooking some of the oven's surfaces
reach dangerous temperatures. The
symbol warns of this danger.
Never touch these surfaces and only use the proper handle.
6.1. Preparation for use and before turning
If the unit has just been installed or if it has not been used for several
days before using it to work you need to clean it completely food as
described in Chapter cleaning, to eliminate manufacturing waste,
accumulations of dust or other substances that
may contaminate food.
6.1.1.
Ignition Control Panel
Press the
(Fig.1), part of the fan. After
20 seconds the message appears on the display
"FLAMES" and activates the audible signal.
6.1.2.
Settings and start cooking
Select the desired cooking program by
pressing
the
button
(Fig.2).
For
programming, see section 5.4.1.
Open the gas cock and press the reset-button
(Fig.3) to light the burner.
If at the end of the 40/50 seconds the writing
“FLAME” appears on the display, check that
the gas pipe is connected properly and that the
gas cock is open. Anyway, it may happen that a
failure occurs during the first starting trial, due to
the presence of air in the gas pipes.
Wait 5 minutes and press again on reset
button (Fig.3) to activate the burner.
After
setting
the
cooking
time
and
temperature required to proceed to the activation
of the belt movement using the button (Fig.4).
1
2
3
4
Summary of Contents for SYNTHESIS 08/50 V PW GAS
