CLEANING
29
Synthesis
06/40V GAS
7. CLEANING
After having cleaned the removable parts, do not forget to clean also the points of
connection between these removable parts and the equipment with jets of water, to prevent
accumulation of dirt and of detergents which could contaminate the products.
Before cleaning turn off the main switch on the electric panel and close the gas cock.
Remember that the equipment must be switched off and at room temperature.
7.1 CLEANING REMOVABLE PARTS
Removable parts can be washed as normal dishes. To avoid that at some points
accumulate dirt or detergent residue that may contaminate processed products, help with tools
not sharp or small brushes.
Do not use abrasive or corrosive tools(such as abrasive sponges or similar) as in the
long run they will damage the glasses and the stainless steel surfaces.
As a rule, it is advisable to clean the removable parts before the food residues get dry.
Cleaning of the drawers of entry and exit should be performed every 4 hours of operation.
7.2
CLEANING OF EXTERNAL PARTS
The crystals are particularly sensitive to sudden changes in temperature that can cause
them to break into tiny fragments. Do not handle the crystals and not bring them into contact
with the water until they are at room temperature.
Use a soft wet sponge with a light not abrasive detergent to clean external stainless steel
or painted surfaces.
Do not use abrasive or corrosive detergents as they would damage the stainless steel
or remove the protective layer and cause the sheets rusting.
Do not use jets of water, as they could penetrate the switchboard and
create a danger of electrocution and/or sudden start-up of the equipment.
Remember that oven off is always connected to the board by the electronic board.
