SR24S_63452v1.06
Welcome,Pilot
1:39 AM
7%
About Controller
Aircraft
Model
Not connected
Camera
Not connected
CGOET_42000B
CGO3P_C2096F
CGO3P_B2002E
CGO3P_C202FB
CGO3P_C20996
CGO3P_B20048
CGO3+_320739
Connection Status
ok
Connection Established
!
TEAM MODE (Wizard & ST16)
Binding Typhoon Wizard™ to Typhoon H
Step 1)
Power on the ST16 Ground Station first, and then switch on Typhoon H.
Do not touch it until the initialization completes. Wait a few seconds for the
camera to align.
Step 2)
Tap the settings icon [ ] in the lower right column of the ST16, and
then switch from single mode to team mode. (At this time, the copter cannot be
controlled by the ST16 anymore, but the CGOET gimbal camera can still be con-
trolled by the ST16.)
NOTICE:
When the system is switched from single mode to team mode, the
Typhoon H Main Status Indicator will start to flash orange rapidly, which means
the copter enters binding mode.
Step 3)
Press and hold the Power Button of the Wizard until the Aircraft Mode
LED glows solid blue. Do not release the Power Button until hearing two beeps
from the aircraft, then release it , which means the Wizard is bound to Typhoon H
successfully.
NOTICE:
The default mode of the system is single mode. The ST16 Ground Sta-
09
NOTICE:
You can also copy a model to bind a new aircraft by long press the orig-
inal model icon and tap “Copy” . Then repeat the above steps.
Step 8)
Tap the back icon [ ] to return to the main screen and you will hear
two long beeps. The flight data will show on the screen.
tion comes bound to the copter and the CGOET from the factory, and controls
both the copter and the CGOET Gimbal Camera.
NOTICE:
After switching from single mode to team mode (Wizard and ST16) on
the ST16 , the Wizard must be bound to the copter and the ST16 Ground Station
must be bound to the camera.The Wizard controls the copter and the ST16
Ground Station controls the CGOET Gimbal Camera.
If you need to switch back to single mode, the operation steps are as follows:
Step 1)
Tap the settings icon [ ] on the ST16 and then switch from team
mode to single mode.
Step 2)
When the Main LED Status Indicator starts to blink, the copter enters
binding mode.
Step 3)
Wait for a few seconds, as the remote control will automatically bind to
the camera and copter. You will hear two beeps from the aircraft when the bind-
ing is successful.
