16-02-05 Page 10 of 19 Operation Instructions for Electronic InBuilt EIB 2002
Thermostat
Unit will not start if thermostat is set on zero or below the temperature sensed by the sensing bulb.
The thermostat-sensing bulb is found behind the hearth.
In some installations the thermostat-sensing bulb may need to be repositioned to accurately sense the
room temperature. Reposition in an unobtrusive place.
Electrical
The unit is connected to the mains supply (240V 50Hz 0.5Amp) via the 3m flex with 3 pin plug.
Commissioning
When installed the installer should operate the heater to ensure that all features are operating
correctly. Refer to the Operation section for instructions.
Eg. On / off operation, Ramp up and down of Fan Speed and flame height.
OPERATION
Power Supply connected and Turned on.
Gas supply connected and turned on.
Fig 7
Thermostat
Thermostat control is at the front of the hearth
The thermostat must be adjusted to a temperature above the room
temperature or the thermostat will not allow the burners to light.
