after all the settings are completed and the image is still not clear, despite the distance and
conditions do not rotate the eyepiece ring (7). Refocus by turning the objective lens ring (6)
only and adjusting the IR illuminator (8) beam focus.
•
To turn off the Sentinel G2+, simply turn off the scope and close the cover over the objective
lens. After mounting the scope onto a rifle for the first time, zero it by following the instruction
in section SIGHTING OF THE SENTINEL G2+.
Note:
The Sentinel G2+ and its IR can be activated using the remote control.
SIGHTING IN THE SENTINEL G2+
WARNING: Be sure to follow proper safety instructions provided by the weapon manufacturer
or vendor.
To test the scope in a lighted area, protect the intensifier by keeping the lens cover over the objective
lens of the scope. Regardless of being in the “ON” or “OFF” position, the IR illuminator will not have
any effect in a lighted environment.
Note
: The sighting of the scope should be performed under the same environmental and temperature
conditions as the ones that the scope will be exposed to during its use.
•
In case when the aiming point (the center of the reticle) does not match the center of target,
adjust by turning the windage/elevation knobs (11) RIGHT & UP until the aiming point
(the center of the reticle) matches the center of target.
•
Take 3-4 control shots trying to be as accurate as possible aiming at the center of the target.
•
Examine the results. If the results are noticeably skewed to one of the sides from the center,
adjust by turning the windage/elevation adjustment knobs RIGHT & UP as needed. Repeat
control shots until the aiming point matches the center of target. Remember: one click
equals 20 mm at 100 m (Sentinel G2+); 1.533 cm (0.5519 inch) at a distance of 100 meters
(110 yards) (Sentinel G2+ MD 3x50); 1.232cm (0.4435 inch) at 100 meters (Sentinel G2+
MD 4x60).
