•
Regular maintenance of the scope will help keep the device free from malfunctions and
untimely wearing of parts and connectors.
Failure to observe these warnings will void the manufacturer's warranty
.
BATTERY INSTALLATION
•
Turn the knob of the battery compartment cover 90º counterclockwise (1) to match the red dot
on the knob with the red dot on the battery compartment cover.
•
Remove the cover by raising it by its lug.
•
Slide in two
АА
batteries so that the “+” and “-” match the polarity on the inner side of the
cover; rechargeable AA batteries may be used.
•
Close the cover of the battery compartment cover and turn the knob of the cover 90º
clockwise.
OPERATING THE SENTINEL G2+
WARNING: It is strongly recommended to test and operate the Sentinel G2+ in dark
conditions or at night time.
•
Install the batteries according to the directions in the section entitled “BATTERY
INSTALLATION”.
•
Enter a dark environment.
•
Remove the objective lens cap by sliding it up on top of the objective lens (2).
•
Activate the scope by turning the power switch to the “ON” position (3).
•
Select the color of the reticle, green or red, by pushing the button (5) until its clicking position.
•
Adjust the reticle brightness by rotating the switch (4).
•
Please select an object of observation at a distance of approximately 100 meters (about 110
yards) away.
•
Set up the objective focus ring knob (6) to be aligned with the mark "100".
•
Focus on the selected object by rotating the eyepiece ring (7). If needed, turn on the IR
illuminator (8) by turning the switcher (3) to the “IR” position.
•
Rotate the IR illuminator lens ring - by doing so it moves forwards and backwards - until the IR
illuminator beam is focused (picture quality turns worse if the luminance level is excessive). If
