- 26 -
3.1.4
Steps of installation
3.1.4.1
Laser tube installation
Install the laser tube on the motorial beam of machine, unpacking the right side cover
and back side cover of beam; and open the upper cover of beam, you can see two laser
tube bracket as follow:
Fig.3-4
Laser tube installation position
Firstly open the two brackets and carefully insert light outlet (negative end) of the laser
tube toward reflector No. 1 into the V-shape bracket as shown in the figure below:
Fig.3-5
Placed the laser tube
Note
The laser tube installation mode is different for CMA1625 series machine,
only need to open the upper cover to lie in the laser tube.
The laser power supply of CMA1325 series machine is lie in the machine unit
inner, but CMA1625 series machine is on the beam, please pay attention
when installing.
Adjust the distance between front and back of laser tube (about 35mm away from No.1
reflector), then button the upper cover part of the laser tube support and screw down the bolt,
fixing the laser tube as follow:
V-shape bracket