4-23
3
．
Fix the machine on the trailer
1) Lower the work equipment correctly
2) Stop the engine and remove the start
key.
3) Turn the safety lock handle to Locked
position.
4) Lock the door and engine hood
5) Place rectangular timber underneath
the front and rear track shoes to
prevent the machine from moving
about. Also, hold it down with chains
or ropes. Be particularly careful to
ensure that the machine does not slip
sideways.
4. Unload the machine from the trailer
1) When loading or unloading the machine, park the trailer on a flat, firm
road. Keep a fairly long distance between the road shoulder and the
machine.
2) Properly apply the brakes on the trailer and insert blocks beneath the
tires to ensure that it does not move.
3) Fix ramps in line with the centre of the trailer and the machine. Be
sure that two sides are at the same level as one another. Make the
angle of the gangplank a maximum of 15°. Set the distance between
the ramps to match the centre of the tracks.
4) Remove the chains or ropes on the machine.
5) Start the engine. If it is winter, turn on the heater to warm the
machine completely.
6) Turn the safety lock handle to Locked position.
7) Lift the arm and bucket, and raises blade.
8) Make sure no unauthorized obstacles in the working area.
9) Moving the platform lock pin and slewing the machine 180°, operate
the work equipment to face to the ramps.
10) Run the engine at the idling speed then travel slowly till the top of the
ramps, then extend the arm when the machine loads on the road,