YOYOCam G3 User Guide v0.2
Page 37
5.
Activate the sensor. For example, open the door if you are adding a door sensor; press the
Test button if adding a smoke detector.
Note:
You have approximately 60 seconds to activate the sensor before YOYOCam cancels
the add operation and reverts to normal state.
6.
When YOYOCam receives the sensor activation signal, it will emit a bleep and sent a
notification message by SMS:
SensorDescription has been successfully loaded
7.
To exit sensor addition mode, press the SET key or wait approximately 60 seconds for the
mode to time out.
Error Responses
Sensor list is full. Please delete old
sensor first.
YOYOCam already has 15 sensors added.
Delete one first to create a space to add the new one.
YOYOCam bleeps repeatedly
Sensor is already added.
Indicator light flashes red/green for
approximately 60 seconds
Sensor has not been detected
Check that you correctly activated the sensor
Note:
YOYOCam Wireless Temperature Sensor automatically pairs itself with YOYOCam and does
not require this procedure. Please follow the instructions supplied with YOYOCam Temperature
Sensor.
Checking wireless sensors
To check which wireless sensors are present:
Command:
#07#
Response:
MMS message including sensor list
Deleting Wireless Sensors
To delete a wireless sensor:
Command:
#112#
SensorDescription
#
Example:
#112#FrontDoor#
Response:
Sensor deleted successfully FrontDoor
To delete several wireless sensors in one command:
Command:
#112#
SensorDescription1
#
SensorDescription2#SensorDescription3# …
Example:
#112#FrontDoor#BackDoor#SmokeAlarm#
Response:
Sensor deleted successfully FrontDoor BackDoor SmokeAlarm
To Delete all sensors:
Command:
#112#
Response:
Sensor deleted successfully
