YOYOCam G3 User Guide v0.2
Page 46
Using the Remote Control
Pairing your YOYOCam with a Remote Control
The supplied Remote Controls are individually paired with YOYOCam at delivery. They can be paired
manually e.g.after a factory reset of YOYOCam or to use one Remote Control for several
YOYOCams. Up to five remotes can be used with each YOYOCam; two are supplied.
To pair a Remote Control with YOYOCam:
1.
Ensure that YOYOCam is on the GSM network during this procedure: Status Indicator
or
1.
Make a short (less than one second) press and release of the RESET key. YOYOCam bleeps
and the Status Indicator LED flashes orange
indicating pairing mode.
2.
Press any button on the remote control. YOYOCam bleeps and LED turns green
for 2
seconds then returns to orange flashing
ready to pair another remote control.
3.
Press RESET to exit pairing mode. In any case pairing mode times out after 15 seconds.
Note:
If the battery in the remote control is low, YOYOCam emits three bleeps and exits learning
mode. Replace the battery in the remote control and try again.
To un-pair all Remote Controls:
Command:
#111#
Response:
All remote controls have been deleted
Arming and Disarming YOYOCam
Press
to arm YOYOCam. The Status indicator flashes
twice a second to indicate that
YOYOCam will arm itself after 20 seconds. The Status indicator shows
when armed.
Press
to disarm YOYOCam. The Status indicator shows
when disarmed.
Note:
If required, YOYOCam can send an SMS notification to the Master when a remote is used to
arm or disarm YOYOCam. See
SMS Notification when alarm is activated or deactivated by a remote
control
in
Advanced Settings
.
Emergency Button
When the Emergency button
is pressed, YOYOCam acknowledges with a bleep. By default,
YOYOCam calls the Master number. When the Master answers, the audio from YOYOCam can be
heard. If the Master does not answer, YOYOCam will call twice more (total three attempts) before
giving up.
