5
INSTALLATION AND SETUP
WIRELESS INDOOR SENSOR
Pairing the wireless Indoor sensor with the console
1 . Remove the battery door of the sensor .
2 . Insert 2 x AA size batteries into the battery compartment . Make sure you insert them the
right way according to the polarity information marked on the battery compartment .
3 .
Close the battery door. The transmission status LED will begin to flash every 1 minute.
Note:
-
If you need to re-assign the sensor channel, firstly slide the channel slide switch to the
new channel that you decided, then press
[ SENSOR ]
key on the console, and then press
[RESET ]
key on the sensor to pair the sensor with the console again .
- Avoid placing the sensors in direct sunlight, rain or snow .
- To avoid the sensor/s and console pairing failure during new console setup, please power
up the sensor/s first, and then press
[ RESET ]
key on the main unit
(no need on sensors) .
Placing the wireless Indoor sensor
Place a screw on the wall that you wish to hang the sensor on . Hang
the sensor onto the screw by the wall mounting holder . You can also
place the sensor on a table by itself .
WIRELESS OUTDOOR SENSOR
Your wireless outdoor sensor measures wind-speed, wind-direction, rainfall, UV index,
temperature and humidity for you .
Pairing the wireless outdoor sensor with the console
1 . Unscrew the battery door at the bottom of the unit and
insert the batteries according to the polarity information
marked on the battery compartment .
2 . Screw on tightly .
3 . Once the batteries are installed, the transmission status
LED will begin to flash.
Note:
- Ensure the battery door screw locked well .
-
Ensure the transmission status LED is flashing every 12
seconds .
Placing the wireless outdoor sensor
Install the wireless outdoor sensor to an open location with no obstructions above and around
the sensor for accurate rain and wind measurement . Install the sensor with the wind meter
end facing North and properly orient the wind direction vane . Secure the mounting stand and
bracket (included) to a post or pole, and allow minimum 1 .5m off the ground .
