20
Step 2: Unfold Bike
Lift the front wheel slightly off the ground while keeping the bike upright. Rotate the front section of
the frame with fork and front wheel until the frame hinge is closed. Make sure no cables or parts of
the frame latch are in hinge as it is closed.
The frame uses an over center clamp with safety latch to hold bike frame closed. Rotate the latch
handle into position to lock the frame closed. Press the handle into position until it is parallel with the
side of the frame. The safety latch should automatically engage when the latch is closed.
Put the kickstand down to support the bike. Use your foot to
move the kickstand down to the ground. Pull the bike back
slightly until the kickstand is fully extended under the bike frame.
Lifting the back of bike from the rear rack will also allow the
kickstand to go fully into position.
Rotate the handlebar assembly into position. The stem riser is
the part of the assembly that contains the hinge and latch for
folding handlebar assembly. Carefully, rotate the handlebar up
until the hinge in stem riser is closed. Make sure no cables or
wires are caught in hinge, caught on frame, or over-extended
while rotating handlebar assembly.
