York YGWH 115, Installation, Commissioning & Operation

Page: 36 / 60

6-10 EN
Form 6S6I-B01C-EOMA-EN (0318)
The following parameters can be checked on the details pages:
is used to clear faults,
is used to clear saved historical fault data.
is used to create trends of the parameters above using the ID to select. Up to five trends of
different parameters can be created. This feature is useful for monitoring parameters during fault
diagnosis, and when unit performance is below standard.
ID Parameter UOM ID Parameter UOM
962 Leaving Condenser Temp. °C 963 Return Condenser Temp. °C
964 Leaving Chilled Temp. °C 965 Return Chilled Temp. °C
1165 Evaporator Pressure kPa 943 Condenser Pressure kPa
1206 Discharge Temp. °C 1207 Oil Pressure kPa
1221 Run Current A 1223 Percent FLA %
949 Liquid Level % 1121 Level Control AO %
1403 Motor Temperature A °C 1404 Motor Temperature B °C
1405 Motor Temperature C °C 1069 HMI Start/Stop
901 Chilled Liquid Flow Switch 902 Mode Switch
1375 High Pressure Switch 904 Low Oil Level Switch
1376 Motor Internal Protect/Power Protect 906 External Interlock
1377 Starter Running Feedback 908 Remote Switch
909 EM Stop 1378 Starter Fault Feedback
911 Condenser Liquid Flow Switch 927 Liquid Pump
1383 Slide Valve Load 1384 Slide Valve Unload
1391 Compressor Star Contact 1392 Compressor Delta Contact
930 Oil Heater 931 Hot Gas Bypass
932 Alarm 935 Unit Running
1393 Liquid Injection Oil Cooling 1394 Oil Supply Circuit
1074 Total Run Hour H 1072 Number of Starts
1080 Unit Type 1082 Control Source
1084 Running Mode 1227 FLA A
1417 Over Current Percent % 1232 Minimum Load Percent %
1418 Leaving Chiller Temp. Setpoint °C 1419 Evap. Low Press. Stop Setpoint kPa
1420 Cond. High Temp. Stop Setpoint °C 1421 High Press. Stop Setpoint kPa
1166 Standby Anti-Freezing 1167 Smart Freeze
1323 Frequency Command Hz 1324 Frequency Running Hz
1325 BUS Voltage V 1326 Output Voltage V
1327 Output Current A 1328 Output Power kW
1329 Heatsink Temperature °C 1367 VSD Run Status