SECTION 7
– WIRE CONTROLLER OPERATION
Don’t touch the screen with sharp points or edges which may damage the
controller. Don’t twist or pull the wires of the controller. Don’t wipe the controller
with benzene, diluent or chemical cloth. Otherwise discoloration or mechanical
failure may occur. To remove dirt, dip the cloth in the water with a neutral detergent
and wring the water before cleaning. Wipe dry the controller with dry cloth. Do not
e xert excessive force on the display or connection in order to avoid changes in
hue.
INTRODUCTION
The touch screen wire controller is standard for remote controls of YCAE units. The functions of
parameter setting, operating status viewing and fault recording are available. Instead of describing
the information above, the wire controller utilizes graphic icons in user interface.
INTERFACE
Area 1: Date and time display;
Area 2: Timer display;
Area 3: Temperature display (include the set point and actual controlled water temperature);
Area 4: Serial number display;
Area 5: Operating mode setting;
Area 6: Running status display;
Area 7: Touch-keys.
The meanings of the icons are listed in Table 30.
Cooke Industries - Phone: +64 9 579 2185 Email: [email protected] Web: www.cookeindustries.co.nz
