![background image](http://html1.mh-extra.com/html/york/ekkc-12-fs/ekkc-12-fs_installation-instructions-manual_3806650018.webp)
by johnson controls
18
GB
Precautions
1. Incorrect tightening can cause problems,
as shown in Fig. 13.
2. If any clearance is left between the ceiling
and the front panel after tightening,
readjust the height of the indoor unit, as
shown in Fig. 14.
3. Connecting the front panel.
Selecting location for the
outdoor unit
- Select a location that satisfies the
following conditions, and those required
by the client.
- Select a location where the air and noise
generated by the unit do not bother the
neighbours.
- Select a very well ventilated location.
- Neither air intake nor discharge can be
obstructed.
- Install in a location that can withstand the
weight and vibration of the unit.
- There can be no danger of inflammable or
corrosive gases.
- Make sure the installation follows the
distances recommended
Installing the outdoor unit
1. Install the unit firmly and in vertical
position, with M10 bolts or greater.
2. Do not install the unit on the roof.
3. To avoid noise, make sure there is
no vibration. To do this, add rubber
washers.
4. Evacuate condensed water to an
appropriate area.
5. Fasten the drain system by means of the
hole inside the outdoor unit.
Fig. 13
Fig. 14
Fig. 15
E
A
D
C
B
A
B
C
D
E
ENJC 12, 18
848
320
540
540
286
ENJC 24
1 018
412
700
572
300
ENJC 36
1 018
412
840
572
378
ENJC 42, 48
950
412
1 250
572
378
AIR LEAK
AIR LEAK
FROM CEILING
CONDENSED WATER LEAK
NO CLEARANCE ALLOWED
INDOOR
UNIT
FRONT
PANEL
INDOOR
UNIT
FRONT
PANEL
It is possible to adjust the height of the indoor unit by
tightening at the corners of the front panel if the indoor
unit is level. This does not affect the connections.
* After fastening the unit, make sure there is no
clearance between the unit and the ceiling.
(6) Fasten the 2 front panel connectors to the unit.
Summary of Contents for EKKC 12 FS
Page 2: ...by johnson controls 2...
Page 64: ...www johnsoncontrols com...