9
COMMENTS/QUESTIONS? EMAIL [email protected]
not properly secure or missing.
You’re almost finished with the assembly,
just a few more miscellaneous items.
15. Insert the small wire plunger into the
bottom of the head light (Figure 16). The
wires should be on the left side of the
plunger when sitting before plugging it
deeply inside the bottom of the head light
(Figure 17). To check its power, first turn
on the LCD display as described above and
then press and hold the “+” button of the
control band until it turns on. To turn it off,
repeat the previous step.
battery, insert the key that was attached
to the battery lock and switch to the right
and hold it while pulling the batter lever
away from the battery to remove the whole
battery (Figure 14). It is recommended
to remove the battery before loading the
Beach Bolt e-bike into your car for security
reasons and to lighten the e-bike for easier
transport. It is best to always store your
battery in a climate controlled setting
(68-80F).
14. To check that the bike’s electrical
system is properly connected, turn on the
back battery by pressing the power button
located under the battery on the bottom,
right-side of the battery if you are standing
behind the back tire. Press and hold the
(“Power”) button located on the control
band on the left side of the handlebar
until the LCD display powers on (Figure
15). If you see it briefly power up and then
suddenly turn off, this means the battery is
Figure 14
Figure 15
Figure 16
Figure 17
