6
COMMENTS/QUESTIONS? EMAIL [email protected]
remove the packing materials from the
very bottom part of the handlebar stem
only, or very bottom of the ‘T’ shape (not
the upper portion).
8. The handlebars have already been
fully wired in and around the frame. The
handlebar assembly must be installed to
the headset with a 4 mm Allen wrench.
Use a 4 mm Allen wrench to loosen the
handlebar stem. Relocate the handlebar
assembly using your fingers and lock the
head stem hinge with the Allen wrench
(Figure 5) after aligning handlebars so
they are center and perpendicular to the
front wheel (Figure 6). The handlebar
grips should roughly line up to whatever
position is most comfortable for your own
riding posture. First tighten with your
fingers and then continue to tighten the
4 screws with the 4 mm Allen wrench
taking care to minimize scratching any
screws. Be sure that the gap on top of the
handlebar mount is even with the gap on
assembly with the fork pointing forward
(Figure 2 Before and Figure 3 After).
6. The front wheel has a quick-release
fork. The front wheel comes pre-installed.
The quick-release mechanism must be set
squarely and firmly tightened to ensure
safety (Figure 4). Please check before
each ride.
7. Renove the stem faceplate before
removing the packing materials, allowing
the handlebar to go directly from pack to
the stem. Then lift the handlebar stem and
Figure 4
Figure 2
Figure 5
Figure 3
Figure 6
