17
D-3. Instruc ons for installing the Gas/Water Valve Controller for use with
an exis ng Valve Manipulator (Non-smart, 12VDC only!) / Motorized Valve
(Non-smart, 2-wire, 12VDC only!)
Wire Cu er/Stripper
Scissors
Wire Nuts
/Connectors (2)
Electrical Tape
U lity Knife
1. These Tools may be Required
1. Your exis ng valve manipulator must be 12 VDC, non-smart, and func onal, while your exis ng
motorized valve must be 2-wire, 12 VDC, non-smart, and func onal
2. Wire nuts (twist-on connectors) are the recommended wire splicing method. Other methods may
be acceptable as long as they provide a secure electrical connec on, with no exposed conductors
2. Get Ready
Remove power from the manipulator/motorized valve by disconnec ng the connec on
cable
1
E xa m i n e t h e c o n n e c to r o n t h e m a n i p u l ato r / m o to r i ze d va l ve c o n n e c o n c a b l e . I f
c o m p a b l e w i t h t h e c o nt ro l l e r ’s c o n n e c o n c a b l e c o n n e c to r, c o n n e c t t h e t wo c a b l e s
to g e t h e r a n d p ro c e e d to p a g e 1 6
2
