YOKOGAWA YTA610, User Manual

Page: 43 / 49

<5. Parameters Lists>
5-2
IM 01C50T01-02EN
Item Parameter Description Write
Initial
Setting
Sensor2
Configuration
Sensor2
Type and
wire
set Sns2 Probe Specify sensor type and number of wires. M
Sensor2
type
Sns2 Probe Type Sensor2 type R Pt100
Sensor2 wire Sns2 Wire Number of Sensor2 wires R 3 Wire
Sensor2 unit Sns2 Unit °C, K,°F, °R, mV or ohm RW °C
Sensor2
damping
Sns2 Damp Specify the response time of sensor1 input
within 0 to 100 seconds.
RW 2s
Sensor2
matching
set Sns2 Matching This function is available only when optional
specification /CM1 is specified. Select “Enable”
or “Disable”.
M
Sns2 CVD
(R0, A, B, C, AI pha,
Delta, Beta)
Sensor2 matching co-efficient. R
Sensor
backup
recover Sensor Recover Backup Operation. M
Sensor Backup
State
Show the backup state. R
Terminal
Temperature
Terminal
temp. unit
Term Unit Specify from °C, K,°F, or °R RW °C
Terminal
damping
Term Damp Specify the response time of terminal
temperature within 0 to 100 seconds.
RW 2 s
CJC function Set CJC Type M
CJC Type “Internal CJC” to use temperature or “Constant
CJC” to use constant value.
R Internal
CJC
Fixed CJC Temp Specify constant value using CJC function. R
Fixed CJC Unit R
Output Sensor burn-
out output
AO Sensor BO Dir Select Sensor Burnout direction. RW High
AO Sensor BO Unit Select mA or % RW
AO Sensor BO Usr
Val
Specify value within 3.6 to 21.6 (mA) or -2.5 to
110%
RW
Output in
CPU failure
AO Alarm Typ Show the current setting of the output direction
in hardware failure which is set using switch on
a MAIN assembly
R
Burst mode Burst mode Off or ON M Off
set Easy Burst Configure Burst mode M
set Detailed Burst Configure Burst mode M
Burst Command Cmd 1:PV
Cmd 2:% range/current
Cmd 3:Dyn vars/current
Cmd 9:Device vars w/status
Cmd33:Device vars
Cmd 48:Read Additional Device Status
M
Burst Variable Code Device Variable for the Burst Message Max 4
slots.
M
Update Period Update Period for Burst mode M
Max Update Period Max Update Period for Burst mode M
Burst Msg Trigger
Mode
Burst Trigger Mode Selection Code
Continuous, Window, Rising, Falling,
On-change
M
Burst Trigger Class RW
Burst Trigger Units Unit for Burst Trigger RW
Burst Trigger Level M
Multi-drop
mode
Poll addr 0 to 63 RW 0
Loop Current mode Enabled: 4 to 20 mA output
Disabled: 4 mA fixed
RW Disabled