YOKOGAWA TB750G, Quick Start Manual, Page: 24 / 37

<4. PARAMETER SETTING>
4-3
IM 12E01A06-02E
4.3 Setting Level
There are modes where parameters regarding output signals and contact outputs can be set.
F4-3E.ai
[YES]
[ * ] For at least second
[NO]
[YES]
[YES]
[NO]
[YES]
[NO]
[NO]
HOLD
*SETP SETPOINTS Mode
*RANGE RANGE Mode
*HOLD SET HOLD Mode
*SERV Service Level
Measurement
mode
*1: Skipped unless either of functions of contact output S1 or S2 is set to “1:
Alarm” in Code 40 or 41 at service level.
*2: Skipped if hold function is set to “*H.OFF: Disabled” in SET HOLD mode at
setting level.
*3: For service level, see Section 4.4.
*1
*3
*2
Table 4.2 Setting Parameters at Setting Level
Mode Setting Parameter Display Setting Range Default
SETPOINTS Alarm setting * SETP *1
High alarm setpoint * S.TB-H –010.0 to 2200.0[NTU] *1 2200.0 (NTU)
Low alarm setpoint * S.TB-L –010.0 to 2200.0[NTU] *1 -010.0 (NTU)
RANGE
Analog output range
setting
* RANGE
Fixed range for output 1,
or fixed range for output 2
* FIXR.1 or
*FIXR.2
Zero point
* ZERO
0000.00 to 2000.00[NTU]
0000.00
(NTU)
Span point * SPAN 0000.00 to 2000.00[NTU] 0100.00 (NTU)
Local range selection * LOCAL
Local range for output 1,
or local range for output 2
*LCL.1 or
*LCL.2
0: Range A, 1: Range B, 2: Range C
0
:Range A
SET HOLD Hold parameter setting * HOLD
Hold function enabled, or
hold function disabled
* H.ON or
*H.OFF
*H.ON (Enabled)
*H.OFF (Disabled)
* H.ON :Enabled
Last measured value, or
fixed value
* H.LST or
* H.FIX
*H.LST
(Last measured value)
*H.FIX
(Fixed value)
* H.LST
:Last
measured value
Fixed value for output 1 * H.mA1 02.0 to 22.0[mA] 22.0 (mA)
Fixed value for output 2 * H.mA2
00.0 to 22.0[mA](0-20mA)
02.0 to 22.0[mA](4-20mA)
22.0 (mA)
CAL/WASH Not available
SERVICE *2
*1: Skipped if alarm setting function is set to “0: Disabled” in Code 51 at service level, or if either function of contact output S1 or S2
is not set to “1: alarm” in Code 40 or 41 at service level.
*2: For service level, see Section 4.4.