19
IM 77C01E31-01EN
SFLC-212-181
19
4.3.3
Enlarged display of integral power consumption
In case electric energy is being displayed by the general measurement display, an electric-energy display is changed to
a normal display (5 digits of integers), and an enlarged display (
2
digits i below decimal point,
3
digits). A
change is performed by SET . After an enlarged display, if a switch is not operated for 10 minutes, it returns to the
usual display automatically.
<Caution > If it continues pushing SET
3 seconds
or more, it will become the setting mode 1.
Normal display Enlarged display
4.3.
4 Setting value check
A voltage range (primary voltage), a current range (primary current), and an alarm-output set point are checked.
Check is
RESET/SHIFT
and
－
are pushed simultaneously and performed.
The change of a set point is carries out by
＋
and
－
. DISPLAY is pushed in case it returns to the original
measurement display. And, if a switch is not operated for 10 seconds after a set point check, it will return to the
original measurement display automatically.
No operation
10 minutes
DISPLAY
RESET/SHIFT
＋
－
Current range
(primary
current)
＋
－
－
＋
A(V) display
V(UV) display Wh display
W display
Measurement display
Primary voltage
Factor display
Input-rating voltage display
(At 3φ3W
,
1φ2W)
－
＋
Time interval,
Contact delay
time
－
＋
Alarm factor,
Upper limit
(lower limit)
value
Return method
Set point check
Voltage range (primary voltage),
Rated voltage
No operation 10 minutes
SET
SET
A(V) display
Watt-hour enlarged display
V(UV) display
W display Wh display
