YOKOGAWA FC400G, User Manual, Page: 56 / 91

< 6. Operation >
6-7
IM 12F5A1-01E
Table 6.2 Setting Item List (Set Values at Shipment and Their Setting at Range)-2
Setting Item
Initial Value
(at Factory Shipment)
Selection and Setting Range
Service
Level
Code 01 (*TEMP) Mode
•Temperature unit selection
°C ( 0 ) °C ( 0 ), °F ( 1 )
Code 02 (*FAIL) Mode
•Reserved code
0 ( 0 ), ( 1 )
Successive operation is not
affected whether ( 0 ) or ( 1 ) is
selected.
•Selection of temperature compensation
range exceeding fail contact output ON / OFF
OFF ( 0 ) OFF ( 0 ), ON ( 1 )
Code 04 (*∆T.SEC) Mode
•Setting of stability determination parameter
*∆T.SEC
10 [ sec ] 5 to 200 [ sec ]
•Setting of stability determination parameter
*∆PPM
0.01 [ mg/l ] 0.01 to 0.05 [ mg/l ]
•Setting of stability determination parameter
*CT.min
7.0 [ min ] 0.1 to 25.0 [ min ]
Code 05 (*NONLN) Mode
•Selection of linear output / two - line- segment
output
Liner output ( 0 ) Linear output ( 0 ),
Two-line-segment output ( 1 )
Code 07 (*DRV V) Mode
•Setting of applied voltage compensation
parameter Start, *DRV V
-0.10 [ V ] (Note 1) -1.50 to 1.50 [ V ]
•Setting of applied voltage compensation
parameter Slope, *V / μA
-0.02 [ V/μA ] (Note 2) -0.10 to 0.00 [ V/μA ]
Code 08 (*CHANG) Mode
•Selection of electrode sensitivity initialization
ON /OFF
OFF ( 0 ) OFF ( 0 ), ON ( 1 )
Code 09 (*WA / CA) Mode
*Wash-Auto Zero Calibration Wash ( 0 ) (Note 3) Wash ( 0 ),
Auto Zero Calibration ( 1 )
Code 10 (*R.RNGE) Mode
*Remote Range switching ON / OFF selection
OFF ( 0 ) (Note 4) OFF ( 0 ), ON ( 1 )
(Note 1) Set to + 0.1V in (to decrease influence of) combined chlorine insensitive version
(Note 2) Set to -0.01V/µA in (to decrease influence of) combined chlorine insensitive version
(Note 3) When ST401G/AZC is specified, initial value is Auto Zero Calibration (1).
(Note 4) When ST401G/RR is specified, initial value is ON (1).