DS1054-009F
P10
3. How to set the pushbutton as centralised
1. Press the transmitter pushbutton
10
times (Configuration Menu). The transmitter LED will flash rapidly.
2. Press the chosen pushbutton
6
times while the LED is flashing.
3. At the end of the press sequence, the LED will flash
6
times to confirm the configuration.
4. How to set centralisation to operate: lights (default), window shutters or “lights and window shutters”.
The centralised pushbutton will operate the light modules by default (MTR2000ER and MTV500ER). Skip this step.
If you want the centralised control to operate the MVR500ER window shutter modules or the lights and the window shutters
at the same time:
1. Press any pushbutton on the transmitter
10
times (Configuration Menu). The transmitter LED will flash rapidly.
2. Press the chosen pushbutton
11 or 20
times while the LED is flashing.
3. At the end of the press sequence, the LED will flash once or 10 times to confirm the configuration.
5. How to define pushbutton operating mode
Follow the instructions in the next paragraph to establish the effect of the centralised pushbutton on the lights or window
shutter modules.
oPeratiNG Mode
Mtr2000er
MtV500er
MVr500er
operating mode 1*
on / off
dim / off
Up / Stop / down
Operating mode
2
-
Recall Memory Level
Intermediate position
Operating mode
3
On
On
Up / Stop
Operating mode
4
Off
Off
Down / Stop
* Default configuration
to change the operating mode of a pushbutton:
1 - Press any pushbutton on the transmitter
10
times (Configuration Menu).
The transmitter LED will flash rapidly.
2 - While the LED is flashing, press the chosen button from
1
to
4
times to select the required operating function.
3 - The LED will flash from
1
to
4
times to confirm configuration.
How to copy a pushbutton onto another pushbutton (between two different transmitters or on the same transmitter).
only the first of the configured connections will be copied: the new button will be set to operating mode 1 (toggle)
1- Press the new button to be created
5
times. The LED will start flashing.
2- While the LED is flashing, press the button to copied until the LED flashes.
How to copy a pushbutton (between two different transmitters)
all connections will be copied: the new button will be set to operating mode 1 (toggle)
On the new transmitter:
1- Press any pushbutton on the transmitter
10
times (Configuration Menu). The transmitter LED will flash rapidly.
2- While the LED is flashing, press the destination pushbutton
12
times. The LED will flash signalling wait state for
approximately 30 seconds.
On the source transmitter:
1- Press any pushbutton on the transmitter
10
times (Configuration Menu). The transmitter LED will flash rapidly.
2- While the LED is flashing, press the pushbutton to be copied
13
times. The LED will light up during data transfer and then
switch off.
How to duplicate the transmitter completely
On the new transmitter:
1- Press any pushbutton on the transmitter
10
times (Configuration Menu).
The transmitter LED will flash rapidly.
2- Press one of the pushbuttons
14
times while the LED is flashing.
3- The LED will flash at the end of the
14
presses.
On the source transmitter:
1- Press any pushbutton on the transmitter
10
times (Configuration Menu).
The transmitter LED will flash rapidly.
2- Press one of the pushbuttons
14
times while the LED is flashing.
3- The LED will flash at the end of the
14
press sequence.
P U S H B U T T O N O P E R AT I N G M O D E
U S E F U L F U N C T I O N S
