INST
ALLER'S
INSTRUCTION
INST
ALLER'S
INSTRUCTION
P16 OF 44
P15 OF 44
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World !
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World !
INDOOR UNIT INSTALLATION
BOLTING THE GRILLE ASSEMBLY TO THE BODY
Install the grille assembly to the body
with the four bolts, spring washers, and
washers.
Wireless unit connection wire wiring
(1)
part A detail.
Connect the connector in accordance with the
(2) Then clamp the lead wire with clamp so that it
does not touch the rotating parts.
Part A detail view
INSTALLING/REMOVING THE INTAKE GRILLE
1. Installing the intake grille
(1) Fully insert the intake grille hooks into the
rectangular holes in the panel.
(2) Close the intake grille, then slide the tw grille
stoppers outward.
o
HANGING PREPARATIONS
(1) Install special nut A, then special nut B onto the
hanging bolt. (Fig.6)
(2) Raise the body and mount its hooks onto the
hanging bolt between the special nuts. (Fig.6)
(3) Turn special nut B to adjust the height of the body.
(Fig.6)
(4) Use a level, or vinyl hose filled with water, to
adjust the unit to level.
Warning
Fig.6
INDOOR UNIT INSTALLATION
INSTALLING DRAIN PIPE
NOTE: Install the drain pipe.
* Install the drain pipe with a downward gradient (1/50 to 1/100) so there are no rises or traps in the pipe.
* Use general hard polyvinyl chloride pipe (VP25) (outside diameter 1-1/4") and connect it with adhesive
(polyvinyl chloride) so that there is no leakage.
* When the pipe is long, install supporters.
* Always heat insulate the indoor side of the drain pipe.
* When desiring a high drain pipe height, raise it up to 15" or less from the ceiling within a range of 6" from the
body. Arise dimension over this range will cause leakage.
6" or less
60 to 78"
Max 15"
Special nut A
Hook
1.18"
or more
Ceiling
19/32"
Special nut B
After installing the body,
tighten the nuts.
Hanging bolt
Vinyl hose
Tighten the bolts to a secure position
