INST
ALLER'S
INSTRUCTION
INST
ALLER'S
INSTRUCTION
P20 OF 44
P19 OF 44
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World !
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World !
HOW TO CONNECT WIRING TO THE TERMINALS
A. For solid core wiring (or F-cable)
(1) Cut the wire end with wire cutters, then strip the insulation about 15/16" (25mm) to expose the solid wire.
(2) Using a screwdriver, remove the terminal screw (s) on the terminal board.
(3) Using a sharp plier, bend the solid wire to form a loop suitable for the terminal screw.
(4) Shape the loop wire properly, place it between the terminal board, and tighten the terminal screw to hold the
exposed solid wire loop securely.
B. For strand wiring
(1) Cut the wire end with a wire cutter, then strip
the insulation to about 3/8" (10mm) to
expose the solid wire.
(2) Using a screwdriver, remove the terminal
screw(s) on the terminal board.
(3) Using a round terminal fastener or plier,
securely clamp a round terminal to each
stripped wire end.
(4) Position the round terminal wire, replace
and tighten the terminal screw using a
screwdriver.
C. Attention:
An all-pole disconnection switch having a
contact separation of at least 3mm in all poles
should be connected in fixed wiring.
WMMS-24EC-V2B(59) 2
WIRING DIAGRAMS
Fuse on PCB
(Condensate water)
WMMS-12EC-V2B(59), WMMS-18EC-V2B(59)
Outdoor
Unit
WMMS-12EC-V2B(59)2, WMMS-18EC-V2B(59)2
WIRING DIAGRAMS
Fuse on PCB
(Condensate water)
(Condensate water)
Fuse on PCB