YMGI VRFI-07EW-D2B(55)5, Installer'S Instruction & User'S Manual

Page: 30 / 37

This is a universal remote control. If the remote control shows the following three kinds of status, then the swing
status of main unit will be:
When the guide louver starts to swing up and down and the unit is turned off the swing of the air guide louver will
stop at current its position.
When shown, indicates the guide louver swings up and down between all five positions.
"I FEEL" BUTTON: Since the indoor unit is normally mounted high up on a wall or attached to a ceiling, the
temperature where the return air sensor is installed (inside the indoor unit) is a higher temperature than occupied
areas, check the air temperature (4 to 7 feet above the floor). If the unit uses the return air temperature as its target
control, then the occupied areas may be colder than the target temperatures in both cooling mode and heating mode.
The facts of air stratification and warm air rising, and cold air dropping will require the users to set up, by
experimenting or by experience, the target temperature may be several degrees higher than what you really want, in
order to reach a satisfied or more precise indoor comfort temperature. This is a common drawback of AC/HP units
made by other manufacturers. With YMGI's
I FEEL feature, this can be avoided, and your comfort level can be
improved. When you press the I FEEL button on the remote control, the unit will use the temperature where the
remote is located as its target temperature control. Once you do so, you will notice a figure of a person surrounded
by stars appear on the remote.
Once the
I FEEL stars appear, the remote will send a signal from the remote-local temperature to the indoor unit,
and the remote-local temperature will supersede the return air temperature as the unit's target temperature. Every
10 minutes a signal will be sent from the remote to the indoor unit updating the remote-local temperature. If at any
time during this process no signal is received by the indoor unit from the remote, the unit will switch back to the
previously set temperature before the
I FEEL feature was activated. To turn the I FEEL feature off, simply press the
I FEEL button until you see the symbol disappear from the remote screen. By doing so, the return air temperature
will take place of remote-local temperature as the unit's target temperature. I FEEL is what YOU WANT. I FEEL
feature brings to you a true comfort level wherever and whenever you want.
SYMBOL DISPLAY
When power is first applied to the unit, but the power has not been turned on by the remote control, the red
power light only is displayed. When the unit has been powered on by the remote control the running LED is
displayed and the current running mode symbol is displayed at the same time.
COOLING: Running symbol and cooling symbol are displayed.
HEATING: Running lamp and heating symbol are displayed.
DRY: Running lamp and dry lamp are displayed.
FAN: Running lamp and fan lamp are displayed.
AUTO: Auto lamp, running lamp and actual running mode are displayed.