ALPHA NUMERIC DISPLAY
•
The setting temperature range for the unit is 61°F to 86°F.
•
Under
AUTO
mode the unit will display 77°F for cooling and 68°F for heating modes.
INTRODUCTION FOR SPECIAL FUNCTION
About Blow function
This function indicates that there is moisture on the evaporator of the indoor unit and will continue to blow after the
unit has stopped to avoid mold.
1. Having set
BLOW
function to on: After turning the unit off by pressing
ON/OFF
button, the indoor fan will
continue running for about 10 minutes at low speed. While in this period, press the
Blow
button to stop indoor
fan.
2. Having set the blow function to off: After turning the unit off by pressing
ON/OFF
button, the complete unit will
be off.
About AUTO RUN
When
AUTO RUN
mode is selected, the setting temperature will not be displayed on the LCD, the unit will be in
accordance with the room temperature automatically to select the suitable running method and to make the
ambient air comfortable.
About TURBO function
At the start of this function, the unit will blow at a super high speed to cool or heat quickly, so the room temperature
approaches the preset temperature as soon as possible.
UNIT DEFROSTING CYCLE
While the unit is running in
HEAT
mode during colder weather, frost can build up on the outdoor coil. This is
common on all heat pump units made by all manufactures. If the unit is running and the automatic defrost mode
is enacted the indoor unit will stop running and display an
H1
code. Once the defrost cycle is finished and the
outdoor coil is defrosted the indoor unit will start to run again in the mode that it was last set up for.
ON DEMAND DEFROSTING
If at any time you would like the send the unit into the defrost cycle, you can choose to by turning the remote
controller off and pressing the
BLOW
and the
MODE
buttons simultaneously. You will see the symbol of
H1
appear on the remote. To stop the defrost cycle simply press the
BLOW
and
MODE
buttons again and the
H1
will disappear from the remote screen.
CHANGING BATTERIES AND NOTICES
1) Press slightly along the arrowhead direction to push the back cover open on the remote control.
2) Take out the old batteries. (As show in figure)
3) Insert two new AAA1.5V dry batteries, and pay attention to the polarity. (As show in figure)
4) Attach the back cover of wireless remote control. (As show in figure)
NOTE:
When changing the batteries, do not use the old or different batteries, otherwise, it can cause the remote control to
malfunction. The operation should be in its receiving range. It should be placed where it is 36 inches away from a
TV set or stereo. If the wireless remote control cannot operate normally, please take the batteries out, wait 30
seconds and reinsert them, if the
remote doesn’t operate normally, please change the batteries. If the wireless
remote control will not be used for an extended period, it is recommended to remove the batteries. Leaving the
batteries in could cause them to leak. This will cause damage to the remote control.
Summary of Contents for VRFI-07EW-D2B(55)5
Page 17: ...SYSTEM LAYOUT INSTALLATION CLEARANCE...
Page 18: ...SYSTEM LAYOUT INSTALLATION CLEARANCE...
Page 19: ......
Page 20: ......
