Yetter 5000-025C, Owner'S Manual

Page: 15 / 52

15
5000-025C ASSEMBLY INSTRUCTIONS
Step 7: Install the Roller Arm Mount Tube inside the clamp channel of the pivot arms using the 5000-138 bolt
bag. Do not tighten this hardware until after the rollers have been installed in Step 8 .
NOTE: Install the Roller Arm Mount Tube on so that the bearing support tab is on the back side to help support
the bearings.
Step 8: Insert the shim washer over the shaft on each end of the roller. Install the bearing over the shaft on each
end of the roller so that the side of the casting that has the bearing protruding past the housing surface is towards
the roller barrel & shim washer. Lift each roller into place, traction bar in front of the rebar, so that the bolt holes
on the cast line up with the mounting tabs on the roller arm mount tube. Install the ½” X 2 ½” bolts & tighten the
½” lock nuts. Once the roller & bearing hardware is fastened, spin the roller to ensure the bearing was installed
correctly. If the roller was installed incorrectly, the roller will not spin or will have drag. Slide the roller mount tube
to gain clearance on each end of the corn head & then tighten the hardware from
Step 7 . The traction bars DO
NOT have to be directly centered under each row.