22.
23.
ASSEMBLY
ASSEMBLY
Using a well calibrated torque wrench finish
tightening the Switch Infinity link bolts.
Torque to 14nm
Slide the upper link over the lower pivot axle hole
on the front triangle. Ensure the Switch Infinity
logo faces the front of the frame.
Grease the lower link axle and install it through
the link from the drive side of the frame. Use a
dead blow hammer to gently tap the axle into
place if necessary.
05.
06.
08.
07.
Apply pink Loctite to the threads on the lower link
axle cap. Install and tighten the cap into the lower
link axle with two 5mm allen wrenches.
Torque to 8nm.
Prep the main pivot axle with pink (222) Loctite
on the threads and a small dab of grease on the
shaft. Slide the swingarm into place. Align the
main pivot (in the Switch Infinity Link) first. Install
the main pivot axle from the non-drive side of the
frame.
Prep the upper link axle with pink (222) Loctite
on the threads and a small dab of grease on
the shaft. Place a rag behind the upper link to
prevent it from damaging the paint. Align the
upper link pivot by sliding the swingarm up or
down on the Infinity Link. Once aligned, insert the
upper link axle from the non-drive side.
Using a 10mm Allen wrench, tighten the main
pivot axle.
Torque to 8nm
09.
10.
11.
12.
While holding the link in place lightly tighten the
bolts. You want them to snug so that the link
does not move and so that the fitting washers
are fully captured, but don’t try to torque them
by hand!