2. Align the holes of the handlebar ⑤ with those of the riser, manually install screws into two rear
holes (without tightening), and insert the dual-purpose bracket ⑥ into the round hole of the
handlebar ⑤ as indicated by the arrow. Then manually install the other two screws and one long
hexagon socket cap screw (C, in the ziplock bag) into three corresponding holes (without tighten-
ing). Finally, vertically tighten five screws down via the hex wrench (B), and press down the
decorative cover ⑨ of the handlebar. Thus, the handlebar installation is completed.
First install two screws here
Hexagon socket cap screw
(C, in the ziplock bag)
Installation Guide
STEP 4: Installation of handlebar and dual-purpose bracket
1. Remove four screws (M6×12) of the riser via the hex wrench (B).
Summary of Contents for M1
Page 19: ......
Page 20: ...ProlinxGmbH Brehmstr 56 40239Duesseldorf Germany EC REP...
Page 21: ...148 210mm 80g 20...