TG Series User Guide
22/86
Reboot GSM/3G Modules
You can reboot a specific GSM/3G module on the Web user interface. This action will not affect other
GSM/3G modules and can ensure the system is running properly.
Procedure
1.
Navigate to
Gateway > Mobile List > Mobile List
, select the desired Module, click
Reboot
.
The module starts to reboot.
2.
Check the module status on
Status > System Status > Trunk Status
.
Enable/Disable GSM/3G Modules
By default, GSM/3G modules are enabled to make outbound calls. If you want to disallow a GSM/3G
module to make outbound calls, you can disable the module.
Procedure
1.
Navigate to
Gateway > Mobile List > Mobile List
, select the desired module, click the
Outbound
Status
. The outbound status is changed.
You can make outbound calls through the GSM/3G module.
You cannot make outbound calls through the GSM/3G module.
Adjust GSM/3G Module Volume
If you find that the call voice is too low or too loud, you can change the relevant GSM/3G module
volume.
Procedure
1.
Navigate to
Gateway > Mobile List > Mobile List
, select the desired module, click
.
2.
On the
General
section, change the
Rx Volume
and
Tx Volume
.
Rx Volume: the received volume of the module.
Tx Volume: the transmitting volume of the module.
Summary of Contents for NeoGate TG200
Page 81: ...TG Series User Guide 81 86...