Yeastar Technology MyPBX U100, Installation Manual

Page: 121 / 197

MyPBX U100&U200 Administrator's Guide
www.yeastar.com Page 105
When using MyPBX as TLS client, specify the protocol for outbound TLS
connections. You can select it as tlsv1, sslv2 or sslv3.
· RTP Port Start
Beginning of RTP port range
· RTP Port End
End of RTP port range
· DTMF Mode
Set default mode for sending DTMF. Default setting: rfc2833
· Max Registration/Subscription Time
Maximum duration (in seconds) of a SIP registration. Default is 3600 seconds.
· Min Registration/Subscription Time
Minimum duration (in seconds) of a SIP registration. Default is 60 seconds.
· Default Incoming/Outgoing Registration Time
Default Incoming/Outgoing Registration Time: Default duration (in seconds) of
incoming/outgoing registration.
· Register Attempts
The number of SIP REGISTER messages to send to a SIP Registrar before giving
up. Default is 0 (no limit).
· Register Timeout
Number of seconds to wait for a response from a SIP Registrar before timed out.
Default is 20 seconds.
· Calling Channel Codec Priority
Once enabled, when dialing out via SIP/SPS trunks, the codec of calling channel
will be selected in preference. If not, MyPBX will follow the priority in your
SIP/SPS trunks.
· Video Support
Support for SIP video or no. Default is yes.
· Max Bit Rate
Configure the max bit rate for video stream. The default: 384kb/s
· DNS SRV Look Up
Please enable this option when your SIP trunk contains more than one IP
address.