Yealink VP59 Teams, Administrator'S Manual, Page: 390 / 533

Call Features
387
...
31-31
If it is not set to 0 (Disabled), the phone will receive the incoming multicast paging call with a higher or
same priority than this value and ignore that with a lower priority than this value when DND is activ-
ated in phone mode.
Default
0
Web UI Directory > Multicast IP > Ignore DND
Parameter multicast.listen_address.X.volume
[1]
<y0000000000xx>.cfg
Description
It configures the volume of the speaker when receiving the multicast paging calls.
If it is set to 0, the current volume of the speaker takes effect. The volume of the speaker can be adjus-
ted by pressing the Volume key in advance when the phone is during a call. You can also adjust the
volume of the speaker during the paging call.
If it is set to 1 to 15, the configured volume takes effect and the current volume of the speaker will be
ignored. You are not allowed to adjust the volume of the speaker during the paging call.
Permitted
Values
Integer from 0 to 15
Default
0
Parameter multicast.receive.enhance_volume
<y0000000000xx>.cfg
Description
It enables or disables the volume enhancement feature when receiving the multicast paging calls.
Note: It works only if “multicast.listen_address.X.volume" is not set to 0. If the value the parameter "mul-
ticast.listen_address.X.volume" is set to 1-15 and the value of this parameter is set to 1 (Enabled), the
receiving volume will be 16-30.
Permitted
Values
0-Disabled
1-Enabled, the receiving volume will be increased by 15 level.
Default 0
Parameter multicast.receive.use_speaker <y0000000000xx>.cfg
Description
It enables or disables the phone to always use the speaker as the audio device when receiving the
multicast paging calls.
Permitted
Values 0-Disabled, the engaged audio device will be used when receiving the multicast paging calls.
1-Enabled
Default 0
Supported
Devices
All phones except CP960
Parameter features.paging_auto_resume.enable <y0000000000xx>.cfg
Description
It enables or disables the phone to automatically resume the held multicast paging call after the
second multicast paging call or a new call ends.
Permitted
Values
0-Disabled
1-Enabled
Default 0
[1]
X ranges from 1 to 31.