Yealink Teams Series, Administrator'S Manual

Page: 70 / 112

| Phone Customization | 70
Permitted Values
It customizes the dial tone.
tone list = element[,element] [,element]…
Where
element = [!]Freq1[+Freq2][+Freq3][+Freq4] /Duration
Freq : the frequency of the tone (ranges from 200 to 4000 Hz). If it is set
to 0 Hz, it means the tone is not played.
A tone is comprised of at most four different frequencies.
Duration : the duration (in milliseconds) of the dial tone, ranges from 0
to 30000ms.
You can configure at most eight different tones for one
condition, and separate them by commas. (for example,
250/200,0/1000,200+300/500,200+500+800+1500/1000).
If you want the phone to play tones once, add an exclamation
mark “!” before tones (for example, !250/200,0/1000,
200+300/500,200+500+800+1500/1000).
Note : It works only if “voice.tone.country” is set to Custom. It is not
applicable to CP960 Phones.
Power Saving
The power-saving feature turns off LCD backlight and LCD display to conserve energy. The phone enters power-
saving mode after the phone has been idle for a certain period of time. And the phone will exit power-saving mode if
a phone event occurs - for example, the phone receives an incoming call , or you press a key on the phone or tap the
touch screen.
Note: If the Screen Saver is enabled on your phone, power-saving mode will still occur. For example, if
a screen saver is configured to start after the phone has been idle for 5 minutes, and power-saving mode is
configured to turn off the backlight and screen after the phone has been idle for 15 minutes, the backlight and
screen will be turned off after the screen saver has been on for 10 minutes.
• Power Saving Configuration
Power Saving Configuration
You can enable or disable power saving, and set the different idle timeout for office hours and off hours.
•
Office Hour : specify the start time and end time of the office hour. You can change the office hours to avoid
affecting your work.
• Idle TimeOut (minutes) : specify the period of time before the phone enters the power-saving mode.
You can specify the following three types of idle timeout:
•
Office Hours Idle TimeOut : specify the idle timeout for office hours.
• Off Hours Idle TimeOut : specify the idle timeout for non-office hours.
•
User Input Extension Idle TimeOut
: specify the idle timeout that applies after you use the IP phone (for
example,press a key on the phone or pick up/hang up the handset).
By default, the Office Hours Idle Timeout is much longer than the Off Hours Idle TimeOut. If you use the phone, the
idle timeout that applies (User Input Extension Idle Timeout or Office Hours/Off Hours Idle TimeOut) is the timeout
with the highest value.