Getting Started
33
3.
Enter the desired values in the IP Address, Subnet Mask, Gateway, Primary DNS
and Secondary DNS fields.
4.
Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5.
Click OK to reboot the phone.
To configure the IP address mode via phone user interface:
1.
Press Menu->Settings->Advanced Settings (default password: admin)
->Network->WAN Port.
2.
Press or to select IPv4 or IPv4&IPv6 from the IP Mode field.
3.
Press the Save soft key to accept the change.
The IP phone reboots automatically to make settings effective after a period of time.
To configure a static IPv4 address via phone user interface:
1.
Press Menu->Settings->Advanced Settings (default password: admin)
->Network->WAN Port->IPv4->Static IP Client.
2.
Enter the desired values in the IP Address, Subnet Mask, Default Gateway, IPv4
Pri.DNS and IPv4 Sec.DNS fields respectively.
3.
Press the Save soft key to accept the change.
The IP phone reboots automatically to make settings effective after a period of time.
PPPoE (Point-to-Point Protocol over Ethernet) is a network protocol used by Internet
Service Providers (ISPs) to provide Digital Subscriber Line (DSL) high speed Internet
services. PPPoE allows an office or building-full of users to share a common DSL
connection to the Internet. PPPoE connection is supported by the IP phone Internet port.
Summary of Contents for SIP-T2XP
