YATO YT-82950, Manual

Page: 9 / 56

9
O R I G I N A L I N S T R U C T I O N S
GB
PRODUCT CHARACTERISTICS
The cordless compressor is a device that allows for in fl ating tyres or other objects, e.g., balls or mattresses with compressed air.
The battery power supply increases the mobility of the product. The correct, reliable, and safe operation of the device depends
on its proper use, therefore:
Read the entire instructions manual before the fi rst use of the device, and keep it for future reference.
The supplier shall not be held liable for any damage resulting from failure to observe the safety regulations and recommendations
speci fi ed in this manual.
PRODUCT EQUIPMENT
The factory packaging should contain: cordless compressor, charging cable, hose, adapter for in fl ating.
TECHNICAL DATA
Parameter Unit Value
Catalogue No. YT-82950
Rated voltage [VDC] 5
Rated pressure [MPa / bar / PSI] 1.0/10/150
Pumping capacity [l/min] 25
Hose length [cm] 25
Weight [kg] 1
Battery type Li-Ion
Battery capacity [Ah] 2.2
Rated battery voltage [VDC] 11.1
Charging time [h] ~4
SAFETY INSTRUCTIONS
Learn how to use the tool. Do not start working or charging before reading the instructions manual. Following the guidelines con-
tained in the instructions manual reduces the risk of injury, electric shock or fi re.
Observe the maximum pressure of the in fl ated products. Use a pressure gauge (built-in or separate) to control the pressure inside
the in fl ated product. Exceeding the maximum pressure may cause damage to the in fl ated product or even its rupture. Rupturing
the product can cause serious injuries.
Periodically check that the readings of the pressure gauge built into the tool match those of the calibrated pressure gauge.
Check the tool for damage before each use. If you notice any cracks, abrasions or other damage, do not use the tool until the
defects are removed.
Check the in fl ation hose for damage. If abrasions, cracks or air leaks of the insulation are discovered, stop using the damaged
hose and replace it with a new hose before continuing work.
Never bend or twist the hose during operation. Bending the hose can reduce its inside diameter even to the point where the air
fl ow stops. This can lead to damage to the hose or even to its rupture, which can result in serious injuries. Bending and twisting
the hose also speeds up hose wear. Never carry the tool holding it by the hose. Do not overtension the hose during operation.
Do not use the device as a blow gun, arti fi cial respiration device, for spraying any substance or any other application not described
in the instructions manual.
Never point the air stream towards yourself, other people or animals. Do not use your fi nger or any other part of the body to check
if the device is pumping air.
Make sure that the device is turned o ff and has a locked power switch before connecting the hose to the device, as well as the
adapter for in fl ating to the hose and the device itself to the product intended for in fl ating.
The device is not intended to be used by children.
Do not operate the device continuously for more than 15 minutes. After this time, stop work and allow the device to cool down
completely. The further operation may result in overheating of the device and its damage. It can also cause fi re or electric shock.
PRODUCT OPERATION
Preparing for operation
Unpack the product by removing all packaging components.
Begin assembly of the hose to the device. The hose fi xing ring has internal protruding elements that should be fi t to the notches
in the hose socket in the device (II). After completely covering the installation socket with the ring, turn the ring clockwise – it will