YATO YT-82320, Instruction Manual

Page: 10 / 56

10
GB
O R I G I N A L I N S T R U C T I O N S
PRODUCT OVERVIEW
The steamer allows for quick and effi cient soaking of wall wallpapers with the use of steam. This makes it easier to remove them
from walls with a spatula. The large tank and the long hose connecting the tank and the steamer allow effi cient and ergonomic
operation. The correct, reliable, and safe operation of the appliance depends on its proper use, so:
Read and keep the entire manual before the fi rst use of the product.
The supplier shall not be held liable for any damage resulting from failure to observe the safety regulations and recommendations
specifi ed in this manual. Use of the product for purposes other than those for which it was intended shall cause the loss of the
user’s rights to the guarantee and under warranty.
ACCESSORIES
The product is delivered complete but requires assembly before operation. The product includes: a steamer, a water tank, a hose
connecting the steamer with the tank and a detachable power cord.
SPECIFICATION
Parameter Units Value
Cat. No. YT-82320
Rated voltage [V~] 230 - 240
Rated frequency [Hz] 50
Rated power [W] 2000
Water tank capacity [l] 4.5
Maximum steam temperature [
O
C] 100
Ingress protection rating IPX4
Protection class I
Weight [kg] 1
SAFETY INSTRUCTIONS
Caution! Read all of the following instructions. Failure to do so may result in electric shock, fi re, or personal injury.
FOLLOW THE INSTRUCTIONS BELOW
Do not use the product in an explosive environment containing fl ammable liquids, gases, or vapours.
Before starting the product for the fi rst time, make sure that the product, its accessories, and the power cord have not been
damaged. If any damage is discovered, it is not allowed to start working with the product. Any damaged components, including
the power cord, must be replaced at an authorized facility. It is not allowed to repair the product on your own.
Always use personal protective equipment such as heat-resistant gloves, work clothes with long sleeves and legs, and work shoes
with an anti-slip sole. Protective goggles should also be worn.
The product is intended for indoor use only. Do not expose the product to any precipitation or moisture. If water and moisture
enters the product, the risk of an electric shock is signifi cantly increased. Do not immerse the product in water or any other liquid.
The room in which the product will be used should be well lit and ventilated. If the operator feels unwell due to steam build-up
and an increase in temperature, operation should be stopped and the room ventilated before resuming work. Seeking medical
attention is required if the symptoms in the operator do not disappear.
Do not use the steamer near light switches, electrical sockets or other electrical equipment. Condensation can cause a short-
circuit which can result in electric shock and serious injury or death.
Do not use the steamer for ironing clothes.
Connect the product to the power network providing the voltages and frequencies indicated on the nameplate of the unit,
exclusively. The plug of the power cord must match the power socket. Do not modify the plug. Do not use any power adapters to
adapt the plug to the socket. An unmodifi ed plug, which matches the socket, reduces the risk of an electric shock.
Use only the power cord supplied with the device. If the cord is damaged, contact an authorised service centre of the manufacturer
to obtain a new cord.
A product with fi rst class electrical insulation must always be connected to an outlet equipped with a protective conductor. The
mains power supply should be equipped with a residual current fuse with a tripping current of 30 mA or less.
After each use, remove the power cord plug from the power socket and disconnect the power cord from the product. Always
disconnect the device from the power supply, if it is left unattended, and before putting it away, disassembling, cleaning or fi lling
with water.