YATO YT-82171, Original Instructions Manual

Page: 17 / 72

17
GB
O R I G I N A L I N S T R U C T I O N S
In case the saw is seized in the material being cut, it is required to immediately release the switch of the tool, disconnect the tool
from the power supply source, and then remove it from the kerf.
It is required to inspect the saw for defects or deformations which might have been caused by the seizure and in case any are
detected the saw must be replaced with a new one. It is also required to check the cause of the seizure, for example to make sure
there are no metal elements in the material being cut, which might cause seizure of the saw. Before work is resumed, it is required
eliminate the cause of seizure of the saw.
Once cutting has been concluded, it is required to remove the rotating saw from the kerf, and only then release the switch.
Once work has been concluded, it is required to carry out maintenance tasks.
MAINTENANCE AND INSPECTIONS
ATTENTION! Before any adjustments, technical service or maintenance actions may be realised, it is required to remove the plug
of the tool from the mains socket. Once work has been concluded, it is required to check technical conditions of the electric tool,
through visual inspection and evaluation of the body and the handles, the electric cable with the plug and the bend protector.
Check also functioning of the electric switch, make sure the ventilations lots are clean, check the sparking of the brushes, the
noise emitted during work, bearings and gears, start-up and uniformity of functioning. During the period of validity of the guarantee
the user must not dismantle the tool or replace any assemblies or parts, which would make the guarantee void. Any irregularities
observed during inspections or during work are a signal to have repairs done in a service point, for which it is required to contact
the manufacturer. Once work has been concluded, the enclosure, the ventilation slots, the switches the additional handle and the
guards must be cleaned, for example with air jet (whose pressure must not exceed 0.3 MPa), with a brush or a dry cloth, without
any chemicals or cleaning agents. Do not use any sharp objects to clean the tool. It is required to dismantle the circular saw and
clean the internal section of the guards, the fixture of the circular saw and the saw itself from dust and other contamination gener-
ated during work. The mobile containment plate of the working table must be cleaned, moved to the extreme external position
and then apply a small quantity of a solid lubricant to its guide. The handles, handwheels and other adjustment elements should
be cleaned with a dry and clean cloth.