YATO YG-04311, Original Instructions Manual

Page: 9 / 27

9
O R I G I N A L I N S T R U C T I O N S
EN
Attention! It is forbidden to fi ll the product with water during its work. Before the fi lling of the
product with water, turn o ff the product, and the plug of power cable has disconnect from the
mains socket. If, during the pouring, water will be splashed, It should be thoroughly dry before
connecting the product to the power supply. The product is only used for water heating, water
cooking and distribution of water. Do not fi ll the product with other drinks, especially ones,
which contain fats or alcohol. Do not use the product to heat up other foods than water. The
level of water in the product must always be between tags specifying the minimum (MIN) and
maximum (MAX) level.After fi lling the tank of the product, you should install and fasten the
cover. It is forbidden to use the product without the installed and attached cover. Do not use
the empty product. Do not fi ll the product with water by immersing it in water. Do not carry
the fi lled product.
Guidelines for connecting the product to the power supply
Before connecting the product to mains, you should make sure that voltage, the frequency
and the performance of the mains correspond to the values on the rating plate of the product.
Power cable plug must fi t into the mains socket. It is forbidden to alter the plug.The product
must be connected directly to a single wall mains socket. it is forbidden to use extension
cables, splitters and double sockets. Circuit power supply network must be equipped with
a grounding conductor and protection for 16 A. Avoid contact of the power cable with sharp
edges and hot objects and surfaces. When the product is working, the power cable must
always be fully unwind, and its location should be set so, it would be no obstacle during the
operation of the product. Placing the power cable can cause a tripping hazard. The power
outlet should be located in such a place, that there would be always possible to quickly
disconnect the power cable plug. When disconnecting the power cable plug, you should
always pull by the plug housing, never by the cable. If the power cable or plug are damaged,
you should immediately disconnect them from the mains and contact authorized service of
the manufacturer for replacement. Do not use the product with a damaged cable or plug.
The power cable or plug can not be repaired in the event of a failure of these elements they
should be replaced with a new ones, free from defects.
PRODUCT SERVICE
Installation starting and operation of the product
The product should be unpacked, removing all packaging elements completely. It is recommended to keep the packaging, it can
be helpful for subsequent transport and storage of the product.
Select the installation location according to the recommendations above. Level the product thoroughly at the installation site.
Wash the product according to the instructions in the section “Maintaining the product”.
Fill the product with water according to the instructions in the manual.
Fasten the cover.
Set the operating temperature. The temperature controller is also a switch, set to the position marked with a line, it turns o ff the
product. By turning the knob clockwise, you can turn it on and then set the temperature according to the value on the knob.
After switching on, the heating indicator will light up and the product will start heating the water. When the set temperature is
reached, the indicator will go out and the cooker will go into the set temperature maintaining mode. This means that it will peri-
odically turn on and o ff .
Warning! If the temperature has been set around 100
O
C or above. The cooker will constantly boil water and the ready light will not
light up. In this case, turn o ff the product with the switch or reduce the temperature setpoint.
A tap is used to distribute water. Place a container under the tap, then press the tap lever moving it to a horizontal position, fi ll the
container with water. Releasing the pressure on the tap lever will cause it to return to a vertical position and stop the water fl ow.
Warning! The water in the cooker can be heated to a high temperature, be careful when distributing water to avoid burns.
Warning! By tilting the tap lever the other way, it is possible to open the tap without having to hold the lever. You can use this