Sigma II User’s Manual
Chapter 5: Parameter Settings and Functions
5-30
5. Electronic gear ratio is given as:
If the gear ratio of the motor and the load shaft is given as:
where m is the rotation of the motor and n is the rotation of the load shaft,
Electronic gear ratio
=
Note: Make sure the electronic gear ratio satisfies the following condition:
0.01
≤
Electreconic gear ratio
≤
100
The servo amplifier will not work properly if the electronic gear ratio exceeds this range. In that case,
modify either the load configuration or the reference unit.
6. Set the parameters.
Reduce the electronic gear ratio to the lower terms so that both A and B are inte-
gers smaller than 65535, then set A and B in the respective parameters:
Set the electronic gear ratio according to equipment specifications.
•
B = [(Number of encoder pulses) × 4] × [motor speed]
•
A = [Reference units (travel distance per load shaft revolution)] × [load shaft
revolution speed]
Parameter
Signal
Setting
Control Mode
Pn202
Electronic Gear Ratio (Numerator)
Range: 1 to 65535
Default Setting: 4
Position Control
Pn203
Electronic Gear Ratio (Denominator)
Range: 1 to 65535
Default Setting: 1
Position Control
B
A
---
m
m
----
B
A
---
Number of encoder pulses
×
4
Travel distance per load shaft revolution (reference unit)
×
n
m
----
B
A
---
B
A
( )
Pn202
Pn203
Electronic Gear Ratio (Numerator)
Electronic Gear Ratio (Denominator)
M
Reference
input pulse
SGDH Servo amplifier
Electronic
gear
SGM
o
H
servomotor
Electronic gear ratio = =
B
A
---
Pn202
Pn203
