Notes for Safe Operation
viii
167646-1CD
HW1481264
Interface Board for Welding
Power Supply
CAUTION
•
Perform the following inspection procedures prior to conducting
manipulator teaching. If problems are found, repair them
immediately, and be sure that all other necessary processing has
been performed.
– Check for problems in manipulator movement.
– Check for damage to insulation and sheathing of external wires.
•
Always return the programming pendant to the hook on the DX200
cabinet after use.
The programming pendant can be damaged if it is left in the
manipulator’s work area, on the floor, or near fixtures.
•
Read and understand the Explanation of the Warning Labels in the
DX200 Instructions before operating the manipulator.
•
Wiring and installation must be performed by authorized or certified
personnel.
Failure to observe this caution may result in fire or electric shock.
•
Check to be sure that there is no foreign matter (metal piece, etc.)
on the board.
Failure to observe this caution may result in personal injury or
equipment damage because of malfunction.
•
Check to be sure that there is no problem (damage, bend, etc.) with
the components of the board.
Failure to observe this caution may result in personal injury or
equipment damage because of malfunction.
•
Connect the cables and connectors properly.
Failure to observe this caution may result in fire or equipment failure.
•
Make sure to properly perform the setting of the switches, etc.
Failure to observe this caution may result in personal injury or
equipment damage because of malfunction.
•
Do not touch the component-mounting surface of the board directly
with a finger.
Failure to observe this caution may result in the failure of IC, etc.
because of static electricity.
•
Do not touch the solder surface of the board directly with a finger.
Failure to observe this caution may result in personal injury because of
solder projection, etc.
•
Avoid shock on the board.
Failure to observe this caution may result in the failure of the board.
8 of 40
