5
I/O Signal Allocation
5.1 I/O Module Setting
5-1
167646-1CD
HW1481264
Interface Board for Welding
Power Supply
5
I/O Signal Allocation
5.1
I/O Module Setting
To use the JANCD-YEW01-E board on the DX200, the I/O module must
be set according to the following procedure.
Check to be sure that the power supply of the DX200 is turned OFF.
Then, install the JANCD-YEW01-E board all of whose switches are
properly set to the inside of the DX200 cabinet. When installing the board,
refer to
chapter 4 “Board Installation”
1. Press and hold [MAIN MENU], and turn ON the power.
– The Main Menu is displays.
2. Select the {SYSTEM} under the Main Menu.
3. Set the security mode to the “Management Mode”.
SUPPLE-
MENT
When setting the I/O module, set the security mode to the
management mode.
When the security mode is set either to the operation mode
or the editing mode, only the setting status can be referred
to.
22 of 40
