YASKAWA CIMR-V7xx20P1 series, Installation Manual

Page: 45 / 64

Drive Parameter Listing
(n110-n127) Section 8
PARA- SETTING RANGE SETTING FACTORY USER PARA.
METER NAME (AND UNITS) INCREMENT SETTING SETTING REF.
0.1 (sec)
0.1 (sec)
0.1
n110 Motor No-load Current 0 to 99 1 (%) (Note 1) 2.2
n111 Slip Compensation Gain (Note 4) 0.0 to 2.5 (Note 2)
n112
Slip Compensation Primary
0.0 to 25.5 (Note 2)
5.22 Delay Time
n113
Slip Compensation Selection 0: Disabled
1 0
During Regeneration 1: Enabled
0: Disabled
n115
Stall Prevention Above Base (level is based on setting of n094 )
Speed During Run 1: Enabled
1 0
(level at Fmax is n094 x 0.4)
0: Follows acc/dec #1 ( n019, n020 )
5.23
or acc/dec #2 ( n021, n022 )
n116
Stall Prevention During Run,
Note: Multi-Function input selectable 1 0
Accel/Decel Time Select
1: Follows acc/dec #2 ( n021, n022 )
always
0: Undertorque detection disabled
1: Detected during constant speed running.
Operation continues after detection
n117 Undertorque Detection
2: Detected during constant speed running.
1 0
Select (UL3)
Operation stops during detection
3: Detected during all frequency conditions.
Operation continues
4: Detected during all frequency conditions.
coast to stop
5.34
0 to 200%
n118
Undertorque Detection Inverter rated current = 100%; if n097 = 0
1(%) 0
Level (UL3) (detection by torque); motor rated torque
becomes 100%
n119
Undertorque Detection
Time (UL3)
0.1 to 10.0 .1
n120 Frequency Reference 9 (Note 4) 0.00
n121 Frequency Reference 10 (Note 4) 0.01 (Hz) 0.00
n122 Frequency Reference 11 (Note 4) (< 100 Hz) 0.00
n123 Frequency Reference 12 (Note 4) 0.00 to 400.00 or 0.00 5.11
n124 Frequency Reference 13 (Note 4) 0.1 (Hz) 0.00
n125 Frequency Reference 14 (Note 4) (>= 100 Hz) 0.00
n126 Frequency Reference 15 (Note 4) 0.00
n127 Frequency Reference 16 (Note 4) 0.00
Drive Parameters - Continued
45
IG.V7.01_new format.qxd 4/18/05 1:21 PM Page 45