NOTE:
Your control panel may be
slightly different from the one shown in
Figure 2.
ATTACHING THE HANDLE AND
CONTROL PANEL ASSEMBLY
(Hardware A)
•
Lift the handles and control panel as-
sembly out and set right side up,
crosswise on the front of the carton.
Caution: Be careful not to bend or
kink the cables.
Cut the rear section of
the carton away.
•
To attach the handles and control panel
assembly to the unit, start hex bolts (B)
and cupped washers (C) (cupped side
towards the frame) into holes in the
frame sides as shown in Figure 3.
There are nuts attached to the inside of
the frame for these bolts.
•
Slide the slotted end of the handles un-
der the cupped washers on the hex
bolts (B).
•
Secure the upper hole in the handles
with cupped washers (C) (cupped side
against the handles) and hex bolts (A).
See Figure 4. Do not tighten at this
time.
•
Pull the snowthrower out of carton.
Check all carton inserts to be certain that
all loose parts and literature have been
removed before the carton is discarded.
NOTE:
Hex bolts (A) and (B) have
a chemical patch which sets after
bolt is assembled.
6
FIGURE 3-Wheel removed for clarity.
Hex Bolt (B)
Cupped
Washer(C)
FIGURE 2
Upper Chute
Crank Assembly
Chute
Assembly
Handles and
Control Panel
Assembly
Lower Chute
Crank Assembly
Shift Rod
Clean-out Tool
(fastened to auger
housing)
Cupped
Side
Crowned
Side
FIGURE 4-Wheel removed for clarity.
Hex Bolt (A)
Cupped
Washer (C)
