model no.
055-0361-0
| contact us: 1.866.523.5218
model no.
055-0361-0
| contact us: 1.866.523.5218
15
STORAGE AND MAINTENANCE
The owner/operator is responsible for all periodic maintenance.
Tampering with the factory set governor will void your warranty.
Improper maintenance will void your warranty.
Maintenance, replacement, or repair of emission control devices and systems may be
performed by any non-road engine repair establishment or individual.
The owner/operator is responsible for all periodic maintenance.
Complete all scheduled maintenance in a timely manner. Correct any issue before
operating the generator.
ENGINE MAINTENANCE
To prevent accidental starting, remove and ground spark plug wire before performing any
service.
Oil
Change oil when the engine is warm. Refer to the oil specification to select the proper grade
of oil for your operating environment.
1. Remove the oil drain plug with a 12 mm socket and extension (not included).
2. Allow the oil to drain completely.
3. Replace the drain plug.
4. Remove oil fill cap/dipstick to add oil.
5. Add 0.6 qt (0.6 L) of oil and replace oil fill cap/dipstick. DO NOT OVERFILL.
6. Dispose of used oil at an approved waste management facility.
Once oil has been added, a visual check should show oil about 1–2 threads from running
out of the fill hole.
If using the dipstick to check oil level, DO NOT screw in the dipstick while checking
Spark Plugs
1. Remove the spark plug cable from the spark plug.
2. Use a spark socket (not included) to remove the plug.
3. Inspect the electrode on the plug. It must be clean and not worn to produce the spark
required for ignition.
4. Make certain the spark plug gap is 0.028–0.031” (0.7–0.8 mm).
5. Refer to the spark plug recommendation section of specifications when replacing the plug.
6. Carefully thread the plug into the engine.
7. Use a spark plug socket (not included) to firmly install the plug.
8. Attach the spark plug wire to the plug.
Saf
ety and Maintenance
