23
AH
AE
4
2
3
4
A
1
Step 11:
Fasten Second Roof Panel & Roof Edge
Position second roof panel, overlap and align with first panel at center. Use wood block to support frame and prevent bending. At row 1 , starting at
side A , fasten panels to Steel Strap using (7)Self Tapping Screws #8 x 5/8". Do the same at row 2 . Place Roof Edge over roof panel 3 , align
holes, then fasten to Steel Strap using (7)Self Tapping Screws #8 x 5/8". Finish fastening panels and edge to the Wood Rafters with (4) Hex Roofing
Screws #8 x 1" at 4 Repeat with second ssembly.
(1) 250-Roof Panel
(1) 254-Roof Edge
(21) Self Tapping Screw #8 x 5/8"
(4) Hex Roofing Screw #8 x 1"
Scrap wood blocks (not supplied) to support assembly when driving tapping screws
Step 8: Attach Roof Panels
Part 2
Hardware
8 x #8 x 1” Roofing Screw
42 x #8 x 7/8” Self Tapping Screw
DO NOT overtighten
screws, could cause
damage to roofing
material
#8 x 1” Roofing
Screws (pre-drill
before installing)
F8.3
Bottom
Top
D:
Place one Main Panel beside the first so the panels overlap and screw holes line up as shown below. Pre-drill
with a 1/8” drill bit then attach Main Panel to (877) Rafter using two #8 x 1” Hex Roofing Screws. Be sure not to
overtighten screws. (F8.3 and F8.4)
E:
Repeat Steps A - D for the second Roof Frame Assembly.
F:
Place one Roof Edge 67 on the bottom of each Roof Frame Assembly so the ends are flush with the outside
ends of each (877) Rafter. Predrill the two end holes with a 1/8” drill bit then attach Roof Edge 67 to (877) Rafters
with one #8 x 1” Hex Roofing Screws per rafter. Attach Roof Edge 67 to Roof Strap with seven #8 x 7/8” Self
Tapping Screws per frame. (F8.3)
G:
For each Roof Frame Assembly attach both Main Panels to Roof Straps with 14 #8 x 7/8” Self Tapping Screws
per frame. (F8.3)
Panels overlap
at the seams
Main
Panel
Main
Panel
F8.4
#8 x 1” Roofing
Screw (pre-drill
before installing)
#8 x 7/8” Self
Tapping Screw
Main
Panel
#8 x 7/8” Self
Tapping Screw
Main
Panel
Roof
Edge 67
Roof Parts
2 x Main Panel
2 x Roof Edge 67
