17
1-866-902-9690
ASSEMBLY
ASSEMBLY
WARNING!
Strictly adhere to all torque wrench tightening specifications. Failure to do so could cause
serious personal injury.
WARNING!
Do not attempt to modify this product or create accessories not recommended for use with
this product. Any such alteration or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING!
To prevent accidental starting that could cause serious personal injury, always remove the
start key from the tool when you are assembling parts.
CONNECT THE BATTERY (See Fig. 5)
When shipped from the factory, the mower’s batteries are disconnected. To connect:
• Press the tabs on the wiring cover and lift the cover to remove.
• Connect the two ends of the battery quick-connect plug together.
NOTE:
Before reinstalling the wiring cover, install the seat as described in the next section.
INSTALL THE SEAT (See Fig. 6)
• Put the seat on a flat ground, Kneel on the seat and hold the back of the seat with one hand, rotate
the adjusting handle upward with another hand to set the seat back to vertical position ,release the
adjusting handle to lock the position.
• Remove flange nuts (A) and bolts (B) from seat mounting brackets.
• Place the seat assembly over the mounting brackets and align holes as shown.
• Reinstall flange nuts (A) and bolts (B) and tighten securely.
• Route seat safety interlock cable through hole in wiring cover, then attach to plug on mower.
• Reinstall wiring cover and make sure it is securely seated.
Fig. 5
Tab
Tab
Battery Quick-
connect Plug
Battery Quick-
connect Plug
Wiring Cover
Fig. 4
