12
13
Fig. 1
Install The Battery Pack
Open the battery compartment cover of the reel
mower. Slide in the battery pack until it locks
with an audible "click". Verify it is securely
installed.
Remove The Battery Pack
Open the battery compartment cover, and push
the push lock buttons on the battery to pull the
battery pack out from the battery compartment
(See Fig. 2).
Battery
cover
Battery pack
Fig. 2
ASSEMBLY
WARNING!
Do not insert the battery and
the safety key until assembly is complete.
Failure to comply could result in accidental
starting and serious personal injury.
WARNING!
Before performing any
maintenance, make sure the battery and
the safety key are removed from the unit.
Failure to heed this warning could result in
serious personal injury.
WARNING!
The product must be fully
assembled before operation. Do not use a
product that is only partially assembled or
assembled with damaged parts.
NOTE:
Before using the reel mower, follow these
instructions to assemble the appliance.
Handle Assembly
1. Insert the ends of the lower handle frame into
the sockets on both sides of the mower base.
Lock with the lower handle knobs provided
(Fig. 3).
Fig. 3
Lower handle
frame
Socket
Lower
handle
knob
2. Fit the middle handle bars on both sides of
the lower handle frame, aligning the holes.
Secure with two sets of handle knobs and
bolts (Fig. 4).
NOTE:
Each middle handle bar has 2 holes
on the top and the bottom. Adjust the handle
assembly to the optimal position by aligning
with the hole at the desired height.
Fig. 4
Middle
handle bars
Handle knob
+ bolt
Lower handle
frame
3. Fit the upper handle frame on both middle
handle bars, as shown, aligning the holes.
Secure with the remaining two sets of handle
knob and bolt (Fig. 5).
Fig. 5
Upper handle
frame
Handle knob
+ bolt
Middle handle
bars
Lower handle
frame
4. Secure the cable with the two cable clips, as
shown (Fig. 6)
Fig. 6
Cable clips
Cable
Grass Collection Bag As Fitting
The grass collecting bag prevents grass clippings
being thrown across your lawn as you mow.
1. Fit the grass collection bag support rod into
the tube of the grass collection bag (Fig. 7)
Fig. 7
Grass collection
bag support rod
Grass collection bag
2. Clip the protective leather profiles onto the
support rod to secure the assembly (Fig. 8).
Fig. 8
Protective
leather profiles
3. Lift the ejector flap to the highest position,
and assemble the grass collection bag onto
the mower by hooking the sockets to both
ends of the roller bar shaft (Fig. 9).
