120v
LITHIUM-ION
TM
10
11
Service
a) Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
CORDLESS GRASS TRIMMER SAFETY
WARNINGS
1. Read the instructions carefully
2. Be familiar with the controls and proper use
of the equipment
3. Wear protective glassed or goggles
4. Never allow children or people unfamiliar with
the instructions to use the machine .
5. Stop using the tool while people, especially
children, or pets are nearby.
6. Only use the machine in daylight or good
artificial light. Never use when visibility is bad.
7. Before using the machine and after any
impact, check for the signs of wear or
damage and repair as necessary
8. Never operate the machine with damaged
guards or without the guards in place.
9. Keep hands and feet away from the cutting
means at all times and especially when
switching on the motor.
10. Take care against injury from any device
fitted for trimming the cutting line length.
After extending new cutter line always return
the machine to its normal operating position
before switching on
11. Only use .808" or .095" nylon cutting line.
12. Never use replacement parts or accessories
not provided or recommended by the
manufacturer.
13. Ensure that the battery pack has been
removed before checking, cleaning or
working on the machine and when it is not in
use.
14. Always ensure that ventilation openings are
kept clear of debris.
15. During assembly take great care when fitting
the guard as this has a very sharp cutting
edge on one side for cutting the nylon line.
16. Never hold the cutter head above foot height
or point it towards people or animals when in
use.
17. If the trimmer starts to vibrate excessively
switch off immediately and have it checked
by a qualified service engineer.
CAUTION:
The cutting head continues to
rotate for a few seconds after switching off.
18. Always remove any sticks and stones etc.
before using the trimmer.
19. Do not cross roads or gravel paths while
operating trimmer.
20. On steep slopes cut across the slope, never
in an up and down direction. Never run while
using the trimmer.
21. Never use the trimmer while it is raining or in
damp weather.
22. Do not overreach, keep proper footing and
balance at all times.
23. Use only genuine spare parts. Only these
spare parts are designed and suitable for
the product. The use of other spare parts not
only voids the warranty, but also endangers
yourself and your environment.
Special Operation safety for the charger
1. Recharge only with the charger specified by
the manufacturer. Do not use the original
charger on other li-ion batteries or on any
other type of battery—fire or explosion may
occur.
2. Check the battery charger, cable and plug
each time before using. Do not use the
battery charger when defects are detected.
Do not open the battery charger yourself and
have it repaired only by qualified personnel
using original spare parts.
3. The charger is designed to use standard
household 100~120 V, 50/60 Hz power
source. The charger’s plug must match the
outlet. Never modify the plug in any way.
Unmodified plugs and matching outlets will
reduce risk of electric shock.
4. Do not abuse the cord of charger. Never use
the cord for carrying, pulling or unplugging
the charger. Keep cord away from heat, oil,
sharp edges or moving parts. Damaged or
entangled cords increase the risk of electric
shock.
5. Make sure the charger cord is located so
that it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
6. Keep the battery charger clean.
Contamination may cause the danger of
electric shock.
7. Protect the battery charger from rain and
moisture. The penetration of water in a
battery charger increases the risk of electric
shock.
8. Do not operate the battery charger on easily
inflammable surfaces (e.g. paper, textiles,
etc.) or in combustible environments. There
is danger of fire due to the heating of the
battery charger during charging.
9. The temperature range over which the
battery pack can be charged is typically 41° F
to 113° F. Therefore, charging efforts outside
the prescribed temperature range may
automatically be blocked by the protection
circuitry of the battery pack. Longest life and
best performance can be obtained if the
battery pack is charged in the normal room
condition.
10. Disconnect charger from the power supply
when not in use. This will reduce the risk of
electric shock or damage to the charger if
metal items should fall into the opening.
11. The charger is for indoor use only.
Special Operation safety for the battery pack
1. If using a battery for the first time, it is not
fully charged form the factory. Before using it,
the battery should be fully charged first.
2. The battery pack should be recharged when
it fails to produce sufficient power on jobs
which were easily done previously. DO NOT
CONTINUE using product with its battery in a
depleted condition.
3. Do not charge the battery in an air
temperature below 41° F or above 113° F.
This is important and will prevent serious
damage to the battery. Longest life and best
performance can be obtained if the battery is
charged when air temperature is about 68° F.
4. When the machine continues to be used and
the battery temperature is above 113° F, the
battery can not be charged, even you put on
the charger. Let the machine cool for some
times and wait the temperature reduced, it
can be charged again .
5. Protect the battery pack against heat, e.g.
including against continuous sun irradiation
and fire. There is a danger of explosion.
6. Do not carry individual battery packs in your
pockets or bags, as they could short-circuit
against other metal items.
7. If an exposed li-ion battery pack dose start a
fire, it wll burn even more violently if it comes
into contact with water or even the moisture
in the air. DO NOT throw water on a burning
li-ion battery!
A fire extinguisher must be
used.
8. If the battery pack becomes too hot to the
touch during charging, disconnect and switch
off immediately. Contact Service Centre
directly.
9. Do not open the battery yourself. There is
danger of a short circuit.
10. When battery pack is not in use, keep it away
from other metal objects, lie paperclips,
coins, keys, nails, screws or other small
metal objects, that can make a connection
from one terminal to another. Shorting the
battery terminals together may cause burns
or a fire.
ASSEMBLY
WARNING:
If any parts are damaged
or missing, do not operate this product until
the parts are replaced. Use of this product with
damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this
product or create accessories not recommended
for use with this trimmer. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power
supply until assembly is complete. Failure to
comply could result in accidental starting and
possible serious personal injury.
WARNING:
Read the Instruction Manual
for the attachment used on this power head and
follow all warnings and instructions. Failure to
follow all instructions may result in electric shock,
fire and/or serious personal injury.
WARNING:
Never install, remove, or
adjust the attachment while power head is
running. Failure to stop the motor can cause
serious personal injury. Never operate power
head without the attachment.
Note:
Remove the battery if fitted before making
any adjustments.
