16
17
Charging the battery pack
WARNING!
Do not use other charging wires which are not recommended by the
manufacturer.
NOTE:
The battery is supplied partially charged. To ensure full capacity of the battery, fully
charge the battery before using it on the product.
1. Connect the battery with the charging wire (Type C adaptor).
2. Select an USB type A power source that match to 5V 1A or less.
3. The green indicator will flash during normal use.
4. The Indicator will show solid green light when battery pack has been fully charged.
Insert the battery
- Insert the battery in to the device; make sure the battery pack is in the right orientation.
IMPORTANT:
Make sure that the battery pack is inserted in the right orientation, torch light
button on up side.
- If you want to uninstall the battery pack, press the battery pack release lever and then
remove the battery pack.
OPERATION
5V 1A
WARNING:
Always wear protective gloves when using the product
WARNING:
Whilst cutting the branch make sure your second hand is kept well
away from the pruner blades
To switch ON:
1. Press the electric button and you will see the green light is ON.
2. Hold the pruner firmly, depress and hold the safety lever with middle fingure and ring
fingure, then active the main trigger with index finger.
To switch OFF:
1. Release the main switch.
2. Press the electric button and you will see the green light is OFF.
NOTE
:
For safety, this pruner could switch off by the blade closed.
-
Depress and hold the safety lever with middle fingure and ring fingure, then active the
main trigger with index finger. Hold in the position until the blade is totally closed.
-
Press the electric button and you will see the green light is OFF.
Cutting Branch
NOTICE!
Risk of damage to the unit!
Be especially careful when working near fences! If material such as fence wire should get
caught up in the cutting unit then switch off the device immediately.
Risk of environmental damage! Before cutting a branch, check no birds are nesting.
NOTE:
Do not use the device to cut the branch with diameter over 14mm.
WARNING
: Whilst cutting the branch make sure your second hand is kept well away from the
Pruner blades
OPERATION
